Hi Steve
Re the bit depth, if you go into Preferences with control+p and press q you
will be on the quality settings. There you can adjust both sample rate and
bit depth. I would be surprised though if you are set to anything less than
16 bit.
Yes, there could well be a difference between the Behringer and stereo mix.
I would use stereo mix as a last resort. Are you able to record from Amazon
with the Behringer - it would need to be set as the default card. You would
have to kill the JAWS speech once recording started if you cannot route it
somewhere else.
Can you connect a set of headphones to listen to the recording coming off
Audacity? That will give you a better idea as to whether the problem is
occurring during the recording, which I suspect it is.
Andrew
From: audacity4blind-bounce@xxxxxxxxxxxxx
<audacity4blind-bounce@xxxxxxxxxxxxx> On Behalf Of Redacted sender "sgsmg49"
for DMARC
Sent: Tuesday, 22 September 2020 11:39 PM
To: audacity4blind@xxxxxxxxxxxxx
Subject: [audacity4blind] Re: Poor Recording Quality
Hello Andrew,
Thanks for responding. I'll try to answer all your questions. It's hard to
tell the quality of the source as well as the audacity playback since it's
coming through the little laptop speakers. My default sample rate is 44.1
and I'm not sure where to find the bit rate setting to check that. My
records and cassettes were recorded through a small Baringer USB mix. For
these current recordings I've used this mix as a separate card to channel
Jaws out of the recording. Would there be a difference using Wasapi instead
of Stereo Mix? I'm open to any suggestions. Thanks again.
Steve
From: audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx>
[mailto:audacity4blind-bounce@xxxxxxxxxxxxx] On Behalf Of Andrew Downie
Sent: Tuesday, September 22, 2020 3:47 AM
To: audacity4blind@xxxxxxxxxxxxx <mailto:audacity4blind@xxxxxxxxxxxxx>
Subject: [audacity4blind] Re: Poor Recording Quality
Hey Steve, disappointing. Some questions follow.
What does the recording sound like in Audacity before you export? If it
sounds good at that point, it seems that something is going wrong in the
export process. If it is muffled in Audacity the problem would be with the
original recording.
You mentioned that you have set recording quality to high. What is the
default sample rate and default bit depth? I suggest a minimum of 44.1khz
and 16 bit respectively as a minimum. Given that your previous recordings
were ok, I suspect you have set those values appropriately.
Does the sound seem ok as you are recording? I have had no experience with
Amazon Music and do not know what quality is like. Again, I imagine you
would have noticed if that was an issue.
Did you record your cassettes and records through stereo mix or via a cable?
Andrew
From: audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx>
<audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx> > On Behalf Of Redacted sender
"sgsmg49" for DMARC
Sent: Tuesday, 22 September 2020 11:09 AM
To: audacity4blind@xxxxxxxxxxxxx <mailto:audacity4blind@xxxxxxxxxxxxx>
Subject: [audacity4blind] Poor Recording Quality
Hello,
I've been doing some recordings from Amazon Music and am not happy with the
quality of the sound of my recordings. I've recorded many cassettes and
records with great results. I'm using a Dell laptop with Real tech card and
using Stereo Mix. I've set the recording level at -6 db. I have recording
quality set to high in preferences. I run amplify before making labels. I
export to mp3 using the insane presets. The end result just doesn't sound
very good, kind of muffled, just low quality sound. Any suggestions? Any
help appreciated.
Steve
