Hello guys!!!!
I have a problem with my computer. I have window7 64Bits, running Sonar8.5
and Jaws14. When I turn on my computer my Jaws start talking at least 5
minutes or less. When I moving around there's nothing at all. I dont know if
it's something lose inside the computer or not. Please Help!!!
Thanks!!!
--- Begin Message ---Hello everyone,
- From: "Fran Franks" <fm.guitarlady@xxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Sat, 6 Apr 2019 22:23:19 -0400
I am installing my very first control surface, a Mackie MCU Pro and one
extension, plus Surface Reader to get it talking. I have done my best to
follow the Surface Reader documentation, but I'm hitting a snag, and I hope
someone in the group here has time to look at this email and suggest what is
going wrong.
My system is running Sonar 8.5 on Windows 7, 64 bit, Jaws 16, and Cake
Talking, and the MCU Pro is connected to the computer via USB.
Here is what I have done so far:
1. Set the mode on the MCU pro to Mackie control.
2. Installed LoopBe30, with default settings and 2 virtual cables,
which Windows calls Internal MIDI.
3. I added the control surface to Sonar with the initial port settings
to test communication between Sonar and MCU pro as follows. Mackie control
1, Input port, MCU Pro USB v3.1, Output port, MCU Pro USB v3.1. The MCU Pro
main unit showed positive functionality and communication with the DAW,
however I'm not getting anything with the extension, a problem to work on
later. Then I reset the input port to internal MIDI 1, and the output port
to internal MIDI 2, the two virtual MIDI cables from LoopBe30. Then I shut
down Sonar before the next step.
4. Opening Surface reader, I added a new surface as Mackie MCU Pro with
the Mackie Control protocol. In the Hardware MIDI Setup, I set the input to
MCU Pro USB v3.1 and output port to Internal MIDI 1. In the Display MIDI
Setup, I set the input port to Internal MIDI 2, and the output port to MCU
Pro USB v3.1.
5. Then, when restarting Sonar, there was no functionality with the MCU
Pro, and later after rebooting the computer and first running surface
reader, I got the following Surface Reader error message. "MCU Pro USB v3.1
could not be opened." Followed by still no function when running Sonar.
Even though Sonar and the MCU Pro initially worked together with the
seemingly same input and output port, MCU Pro USB v3.1, I wonder if this is
somehow part of the problem in Surface Reader despite the care I took in
following their documentation. But, that is a very uneducated guess at
this point.
I hope someone here can point me in the right direction.
Best regards,
Fran Franks
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
--- End Message ---
