About wow and flutter, I have used Doppler effects such as the one in Gold Wave to fix tape drag problems. If the pitch rises from too low to normal over the selection, you have to set the Doppler to lower the pitch from too high to normal over the same selection and by the same amount. It's trial and error even for a simple selection. Fixing a constant wow and flutter such as that found on an off-center record or worn-out tape deck would require constant balancing of the pitch. This is tedious for a blind person but probably easier for a sighted person because they probably just have to straighten out a squiggly line on the wave form or something.
Bob.----- Original Message ----- From: "Chris Smart" <chris_s@xxxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, December 14, 2010 1:01 PM Subject: [ddots-l] Re: Demagnetizing a Microcassette Recorder
At 12:46 PM 12/14/2010, you wrote:What's the best way to clean up the audio in Sonar?well, you might need to adjust pitch, equalize, or maybe remove background hiss if you have sound forge and its Noise Reduction plug-in. I have yet to find a fix for problems like wow and flutter, and asimuth alignment problems.PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq
