I sent it to ddots-l
At 02:41 PM 2/14/2017, you wrote:
Chris ,
This came to me ,Not sure if it ment too?
Greetings
Goran
-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Chris Smart
Sent: Tuesday, February 14, 2017 9:31 AM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Re: SSD/HD
I have a Samsung SSD850Pro here. They've since come out wiht an even faster one.
At 10:14 AM 2/14/2017, you wrote:
>DJX,
>
>SSDâs are new to me. I understand and agree with th your first
>paragraph, (had to look it up).
>So what brand and model are best used in DAWS?
>There are many choices out there. Do you know which is most popular? Or
>which is the fastest long lasting workhorse.Ã Comments greatly
>appreciated.
>Andre
>From: ddots-l-bounce@xxxxxxxxxxxxx
>[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of DJX
>Sent: Tuesday, February 14, 2017 5:47 AM
>To: ddots-l@xxxxxxxxxxxxx
>Subject: [ddots-l] Re: SSD/HD
>
>Just keep in mind, not all SSD are created equally, this is crucially
>important for daw use. You have to take controllers into account, data
>management and IOPS, as well as read lifetime and write lifetime. Since
>you are reading and writing to the drive more than usual, it is
>important to have an ssd with a good read and write lifetime, as well
>as a high number of IOPS for good and actually fast operations, as well
>as a decent amount of years of use.
>
>When used in the wrong configuration, an ssd could be no faster than a
>7200rpm rotational.
>
>Speaking of rotationals, they also vary in performance, and careful
>considerations must be taken here as well. Everything from rotational
>speeds, data cache size, any power saving features or data optimization
>features (both of which hurt performance) must be accounted for.
>In this sector, not all brands are equal either; some have a higher
>failure rate than others.
>
>Also remember, if you are using a laptop for example be very careful
>what buss you use for the drive, as a bandwidth issue could develop
>when using external drives on the same buss as your audio interface for
>example.
>
>HTH, DJX
>
>From: ddots-l-bounce@xxxxxxxxxxxxx
>[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Andre Jarreau
>Sent: Monday, February 13, 2017 10:07 PM
>To: ddots-l@xxxxxxxxxxxxx
>Subject: [ddots-l] Re: SSD/HD
>
>Ok, one less mystery. Thanks
>From:
><mailto:ddots-l-bounce@xxxxxxxxxxxxx>ddots-l-bounce@xxxxxxxxxxxxx
>[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Michael Ciarciello
>Sent: Monday, February 13, 2017 8:36 PM
>To: <mailto:ddots-l@xxxxxxxxxxxxxxxx>ddots-l@xxxxxxxxxxxxxxxx
>Subject: [ddots-l] Re: SSD/HD
>
>Yes indeed Andrey you can either use an SSD and or Spinning drive.The
>SSD drive stream loads faster then the motorized drive.
>There is one thing Iâd like to point on the SSD SD drives and that is
>their life spans.
>I have been told that the SSD drive can last 10 years where as the
>motorized lasts longer than that, however its all six to one half a
>dozen, and between you, me and the lamp post, SSD drives are faster
>lol.
>
>
>On Feb 13, 2017, at 6:46 PM, Andre Jarreau
><<mailto:andre.jarreau@xxxxxxxxxxxxx>andre.jarreau@xxxxxxxxxxxxx> wrote:
>
>Hi Michael,
>Thanks for responding. So a spinning HD is not required for recording
>but is cheaper. Cost is the only factor. Right?
>Andre
>
>From:
><mailto:ddots-l-bounce@xxxxxxxxxxxxx>ddots-l-bounce@xxxxxxxxxxxxx
>[<mailto:ddots-l-bounce@xxxxxxxxxxxxx>mailto:ddots-l-bounce@freelists.o
>rg]
>On Behalf Of Michael Ciarciello
>Sent: Monday, February 13, 2017 5:28 PM
>To: <mailto:ddots-l@xxxxxxxxxxxxxxxx>ddots-l@xxxxxxxxxxxxxxxx
>Subject: [ddots-l] Re: SSD/HD
>
>Hi Andray a hard drive is very necessary to record your material.
>If you are using S/onar it is best that you use the second drive to
>stream and record all your music data.
>Of course an internal second drive is alway the best, but in situation
>where you are using a laptop, then you really have no choice unless you
>configure your lap top to have to drives installed.
>If thatâs not the case then a external USB is is fine for streaming, but
>you should go with a USB 3 type drive.
>Now a days SSD drives are becoming more and more common which means the
>drive has not moto which means the drive can really work at a fast
>rate, but SSD drives can be expensive, however Iâve seen them as low
>as $200.00 for a 500GB which means that the moterized drives might be a
>thing of the past in the not to distant future. For the moment a
>motorized drive running at 72000 RPM is what you should go for and you
>can get a
>3 terabyte drive for as low as $180.00.
>CGate, and or Western Digital are two good brand of hard drives.
>Hope this helps.
>Cheers.
>
>On Feb 13, 2017, at 3:18 PM, Andre Jarreau
><<mailto:andre.jarreau@xxxxxxxxxxxxx>andre.jarreau@xxxxxxxxxxxxx> wrote:
>
>Hi Guys,
>Is a hard-drive essential for recording? Is an external HD for back up only?
>
>Best
>
>
><https://www.avast.com/antivirus><~WRD000.jpg>
>This email has been checked for viruses by Avast antivirus software.
><https://www.avast.com/antivirus>www.avast.com
>
>
>
>
><https://www.avast.com/antivirus>
>Description: Description: Image removed by sender. Avast logo
>
>This email has been checked for viruses by Avast antivirus software.
><https://www.avast.com/antivirus>www.avast.com
>
>
>
>
>
><https://www.avast.com/antivirus>
>Description: Description: Image removed by sender. Avast logo
>
>
>This email has been checked for viruses by Avast antivirus software.
><https://www.avast.com/antivirus>www.avast.com
>
>
>
>
>----------
><https://www.avast.com/antivirus>
>Avast logo
><https://www.avast.com/antivirus>
>
>This email has been checked for viruses by Avast antivirus software.
><https://www.avast.com/antivirus>www.avast.com
>
>
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subjectsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subjectúq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
