Hi. Okay thanks, I figured that out and loaded a couple patches to try them out. I'm not blown away, but it's nice. However, I'm getting terrible clipping! I looked with the jaws cursor and I found some db meters but taking them down doesn't make a difference. And changing the volume on my midi controller does bring the volume down but it doesn't really help the clipping. I'm running it through the tascam FW1884 using the acio drivers and out into my active samsung rubican monitors. Thanks, Cameron. -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Gordon Kent Sent: Wednesday, May 09, 2007 1:06 AM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: Synthergy ivory 1.5 setup help? Cameron: You need to load the piano you want from the properties window of ivory itself. With your jaws cursor, you need to find the line that has something like a pair of asterisks and then the word default. You will need to use your real mouse to click on the word default, the jaws mouse click does not work. This will pull down a drop down list of all the available presets. Pick one and press enter, then wait a few seconds for it to load. Gord ----- Original Message ----- From: "Cameron Strife" <cameron@xxxxxxxxxxxxxxxxx> To: <ddots-l@xxxxxxxxxxxxx> Sent: Tuesday, May 08, 2007 10:54 PM Subject: [ddots-l] Synthergy ivory 1.5 setup help? > Hi. I just installed synthergy ivory 1.5 and the vst plug in shows up > in sonar. I opened the stand alone ivory application and set the midi > in and the audio in. I can't figure out how to set the piano or > preset for that piano however. So I am getting no audio output. I > opened a new session in sonar and inserted the ivory vst. When I went > to set the bank and patch though, it just said bank zero, patch zero, > one, two, etc. And again, I got > no audio. What's up with this? > > Any help would be great. > > Thanks a bunch, > > Cameron. > > ** To leave the list, click on the immediately-following link:- > ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] > ** If this link doesn't work then send a message to: > ** ddots-l-request@xxxxxxxxxxxxx > ** and in the Subject line type > ** unsubscribe > ** For other list commands such as vacation mode, click on the > ** immediately-following link:- > ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] > ** or send a message, to > ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq > > ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq