Do your imported files start at measure 1? Check to see if they are loaded at say time 1 hour. Jean Visitez mon site / Visit my site at http://www.studiomontebello.com ----- Original Message ----- From: "Chris Smart" <chris_s@xxxxxxxxxxxx> To: <ddots-l@xxxxxxxxxxxxx> Cc: <jsonar@xxxxxxxxxx> Sent: Saturday, October 30, 2010 6:35 PM Subject: [ddots-l] What Would Cause No Output From Sonar? > Hi folks. > > What would cause no playback output in Sonar? > > I'm trying to set up a new project, importing many 24-bit wave > files into tracks. I've varified with Winamp and Sound Forge that > the files are playable and the correct bit depth/sampling > rate. And yet, when I load up the usual AAA template and start > importing, I hear nothing but silence and nothing shows on the peak > meters as reported by CakeTalking. > > Before someone says it, yes I've made sure no tracks or busses are > muted or soloed. Hahahaha. The master bus output is to the usual > device. > > I've even loaded up an old project and it plays fine! > > So, is there something else I can check here? I'm starting to panic! > > Thanks for any suggestions, > > Chris > > I'm using the latest Sonar producer and CakeTalking if that helps any. > > PLEASE READ THIS FOOTER AT LEAST ONCE! > To leave the list, click on the immediately following link: > ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe > If this link doesn't work then send a message to: > ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > unsubscribe > For other list commands such as vacation mode, > click on the immediately following link: > ddots-l-request@xxxxxxxxxxxxx?subject=faq or > send a message, to > ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > faq > > PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subjectúq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq