[duxuser] single sided braille
- From: "Brett Winchester" <BWinches@xxxxxxxxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Wed, 13 Jul 2005 11:31:24 -0600
I am running a Juliet pro60 and the little brother to same via a wan
with 10.5. We want to send some jobs through these printers but have
them only print on one side of the page. The settings for the embosser
setup have a checkbox for treat as interpoint embosser and the check
state of this button does not seem to give us any difference from our
default duplex mode.
Is there a quick and dirty way to do this on the fly?
Thank you!
BRETT K WINCHESTER PM KD7JN
VOLUNTEER SERVICES & INFORMATION RESOURCES
bwinches@xxxxxxxxxxxxxxxxx
http://www.icbvi.state.id.us/brochure/radio.htm
IDAHO COMMISSION f/t BLIND & VISUALLY IMPAIRED - ICBVI
P O BOX 83720, 341 W WASHINGTON, BOISE IDAHO 83720-0012
208-334-3220 ext 104 +7=voice mail after hours, Fax
208-334-2963
Member IAAIS International Association of Audio Information Services
http://www.iaais.org
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
