Hi Monte, Are you positioning your cursor at the beginning of the file before your invoke the Grade 1 command? George. -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Monte Single Sent: 13 September 2006 23:28 To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] translate to grade 1 I think I am where Paula started a while ago. Using DBTW 10.3, by default I get Grade 2 braille when I translate. Some students Grade 1. I have a file open, I go to Layout, Tanslate codes and select grade l; when I use Translate in the File menu I still get grade 2 braille. What am I leaving out or missing? Thanks, Monte * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *