On 03.04.2012 17:23, Mike Power wrote: > I am looking at building my own python. I am 6'5" so I thought I > would take advantage of my height and build a 700C python. To make > sure I could build it, and just to give breath to my concepts I > created a design in Blender. Below is a short video. Anybody want to > share their thoughts? I am most concerned about the strength of the > union between the hinge and the bicycle seat. A nice and slender design! I think the frame won't be stiff enough at several places: * the bottom bracket: there is generally a lot of torsion going at that place and your design with the one tube going down along the wheel won't prevent the BB from wiggling. * another typical place is the pivot area. I believe that the rear part connecting to the pivot allows to much torsion and bending. * the rear wheel has two vertical tubes going to the seat and will allow the rear wheel to wiggle sideways. I am unsure about the tube going up right in front of the seat. I think that it will be annoying. best regards, Dirk > > http://www.youtube.com/watch?v=uFA_Og78W4c > > Mike Power > ============================================================ > > This is the Python Mailinglist > > //www.freelists.org/list/python > > Listmaster: Jurgen Mages jmages@xxxxxx > > To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx > with 'unsubscribe' in the subject field. > > ============================================================ > > ============================================================ This is the Python Mailinglist //www.freelists.org/list/python Listmaster: Jurgen Mages jmages@xxxxxx To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx with 'unsubscribe' in the subject field. ============================================================