[python] Re: steering
- From: "Carl Punton" <carlpunton@xxxxxxxxx>
- To: python@xxxxxxxxxxxxx
- Date: Fri, 12 Oct 2007 00:44:16 +0200
Hi Stefan,
I've used 12mm on the Python I'm building, should be strong enough, some
people have used 10mm, personally I would only use 10mm if they were spaced
a long way apart, say 25cm to reduce the loads on them. Also the one in you
picture has a female thread (needs a bolt), if you use one with a male
thread it will take nuts then you can make adjustments to the steering
angle. Generally the size of the thread matches the size of the hole in the
swivel.
Carl.
On 11/10/2007, Stefan Bartels <sbartels@xxxxxxxx> wrote:
>
> A short question: if I do not use a BB for steering joint but something
> like this: (or rather two of them one above the other) what dimension should
> they be (diameter of the axis to be pushed through the hole)?
> Thanks for any suggestions!
> Stefan
> [image: gelenkkopf]
>
Other related posts:
