The power connector should be C not barrel. TheCSI-2 port is the bar right
next to the 3.5 jack. To connect it you pull the lid up and make sure you
have the side of the ribbon cable with the ridge toward the USB ports.
Slide it straight down and the thing you pulled up will grip the cable and
lock in place.
Ken
-----Original Message-----
From: raspberry-vi-bounce@xxxxxxxxxxxxx <raspberry-vi-bounce@xxxxxxxxxxxxx>
On Behalf Of Pranav Lal
Sent: Wednesday, January 20, 2021 10:54 AM
To: raspberry-vi@xxxxxxxxxxxxx
Subject: [raspberry-vi] Raspberry pi 8GB: power supply and csi connector
Hi all,
I have a new raspberry pi 8GB system.
1. I ordered the official power supply. Does the supply have a barrel
connector?
2. I have the new camera module, where is the CSI port and how do I connect
the ribbon cable?
Pranav
===========================================================
The raspberry-vi mailing list
Archives: //www.freelists.org/archives/raspberry-vi
Administrative contact: <mike.ray@xxxxxxxxxxxxxx>
-----------------------------------------------------------
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi
Foundation.
This list is not affiliated to the Raspberry Pi Foundation and the views and
attitudes expressed by the subscribers to this list do not reflect those of
the Foundation.
Mike Ray, list creator, January 2013
===========================================================
The raspberry-vi mailing list
Archives: //www.freelists.org/archives/raspberry-vi
Administrative contact: <mike.ray@xxxxxxxxxxxxxx>
-----------------------------------------------------------
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi
Foundation.
This list is not affiliated to the Raspberry Pi Foundation and the views and
attitudes expressed by the subscribers to this list do not reflect those of the
Foundation.
Mike Ray, list creator, January 2013
