[wdmaudiodev] Re: Debugging USB audio at the hardware level
- From: Clemens Ladisch <clemens@xxxxxxxxxx>
- To: wdmaudiodev@xxxxxxxxxxxxx
- Date: Thu, 08 Oct 2009 09:41:40 +0200
Martin Gagnon wrote:
> By using a Linux OS and reproducing the same problem, we were able to
> get a lead further towards the IN control endpoint from our USB audio
> device. Again, for some reason, the bus driver is resetting the device,
> and it seems that there is a timeout on the in transactions that is
> happening (the IN transactions are at every millisecond, which we
> believe is way too often for a control endpoint sending HID input value
> from the volume up/down buttons on the chip).
>
> So we went ahead and disabled the HID control device from our USB audio
> device, and the problem goes away. We still want to understand why this
> situation happens.
In Linux, you can enable "USB verbose debug messages" (CONFIG_USB_DEBUG)
in the kernel configuration. This might tell you why the reset happens,
and who initiates it.
> Does anybody know if an IN transaction for reporting button control
> value makes any sense to happen every millisecond?
I'd guess the drivers just use the interval from the descriptor.
Best regards,
Clemens
******************
WDMAUDIODEV addresses:
Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx
Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe
Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe
Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx
URL to WDMAUDIODEV page:
http://www.wdmaudiodev.com/
Other related posts:
