Hi everyone, I have an AVStream filter that has one sink pin and one source pin. However, the source pin is not meant to be used as a Capture device...rather, my driver internally connects the source pin to another sink pin on another filter. My problem is that Sysaudio is seeing my source pin and assuming that my filter is a capture device, and so my device is showing up as a recording device in the Sounds and Audio control panel. I need this source pin to connect to the sink pin, so I can't get rid of it, and if I change the communication parameters, I can no longer connect to the sink pin. Is there a way to prevent Sysaudio from assuming my source pin is a capture pin? Thanks for any help, Jeff ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.com/