Sounds like a bug in the test. Check to see if it is covered by an existing
errata; if not, file a bug via Connect.
From: Neetu Sand<mailto:neetu.freelist@xxxxxxxxx>
Sent: Wednesday, April 5, 2017 10:21 PM
To: wdmaudiodev@xxxxxxxxxxxxx<mailto:wdmaudiodev@xxxxxxxxxxxxx>
Subject: [wdmaudiodev] Re: Wave test on MIDI Adapter with WLK
Hi Matthew,
I have run all MIDI audio codec tests and all of them pass except three tests:
- Audio Codec - Wave Test - Basic
- Audio Codec - Wave Test - Certification
- Audio Codec - Wave Test - Functional
Attached is the error shown in Log. Error says that selection criteria did not
match any test but still it is marked as failed.
Thanks,
Neetu
On Wed, Apr 5, 2017 at 9:55 PM, Matthew van Eerde
<dmarc-noreply@xxxxxxxxxxxxx<mailto:dmarc-noreply@xxxxxxxxxxxxx>> wrote:
The audio tests show up because MIDI uses the KSCATEGORY_AUDIO interface. When
you actually run them they should notice that there are no actual audio pin
factories associated with your device, and skip.
From: Neetu Sand<mailto:neetu.freelist@xxxxxxxxx>
Sent: Wednesday, April 5, 2017 5:27 AM
To: wdmaudiodev@xxxxxxxxxxxxx<mailto:wdmaudiodev@xxxxxxxxxxxxx>
Subject: [wdmaudiodev] Wave test on MIDI Adapter with WLK
Hello,
I have a device that supports both WDM and MIDI interfaces and I am running HLK
tests on both. However when I create a project using HLK studio, All tests
under "Audio Codec" category, are also listed for MIDI device.
MIDI driver is a DMUS UART miniport. Is there something wrong in INF that I
need to correct?
Thanks,
Neetu