Gentlemen, I'm in a desperate situation: I have to change something minor, but my software guru isn't available.... We are operating a self written software, which communicates with up to three codecs (generic drivers, PCM 2902). To operate correctly we have to setup the audio parameters manually to "44100-stereo-16bit-microphone stereo" for each detected codec (no idea why) when we install our software to a new PC. This works *mostly* but sometimes the settings are lost and then the communication is disturbed and for our customers it's too difficult to make these setups. Question: Is it possible by any sort of short program to setup there parameters each time the PC is started? If yes we could start this program first to ensure the correct settings and then call our main program. As said, my software guru isn't availble, so if anybody can send me any ready utility it would be very helpful. OS is WIN7. Thanks and best regards Peter ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.com/