[ddots-l] AW: AW: Re: control surfaces
- From: "Stefan Albertshauser" <stefan.albertshauser@xxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Wed, 13 May 2009 17:09:33 +0200
MessageThe only thing, I want to do is to navigate to the properties dialog
of the surface in order to reassign the knobs. The only thing in the
tutorial was the control of automations.
-----Ursprungliche Nachricht-----
Von: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx]Im
Auftrag von Stefan Albertshauser
Gesendet: Mittwoch, 13. Mai 2009 17:02
An: ddots-l@xxxxxxxxxxxxx
Betreff: [ddots-l] AW: Re: control surfaces
I'm using a miditech MTB-Command, which supports the Mackie Protokol.
-----Ursprungliche Nachricht-----
Von: ddots-l-bounce@xxxxxxxxxxxxx
[mailto:ddots-l-bounce@xxxxxxxxxxxxx]Im Auftrag von Kevin Gibbs
Gesendet: Mittwoch, 13. Mai 2009 16:56
An: ddots-l@xxxxxxxxxxxxx
Betreff: [ddots-l] Re: control surfaces
What control surface are you using?
-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx
[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of neville
Sent: Wednesday, May 13, 2009 9:06 AM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Re: control surfaces
Press alt O for options and then press c for control surfaces. Tab
down to add a control surface and choose yours from the list. Press tab
again for in puts and then again for out puts. The first tab is the in put
and the second tab is the out put. After you have done this you can press
alt F4 to close the dialog. That's it.
May the peace of God that passes all understanding guard your heart
and mind in Christ Jesus
God Bless You!
email neville@xxxxxxxxxxxxxxxx
Website
http://www.nevillepeter.com
phone number 407-222-4488
--------------------------------------------------------------------------
From: ddots-l-bounce@xxxxxxxxxxxxx
[mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Stefan Albertshauser
Sent: Wednesday, May 13, 2009 8:08 AM
To: Ddots-L@xxxxxxxxxxxxx (E-Mail)
Subject: [ddots-l] control surfaces
Hi, I want to configure my new control surface. Where can I find the
properties dialog? or: in which lesson in the tutorial do I find the right
informations? I've already searched Lesson 31.
Thanks Stefan
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.325 / Virus Database: 270.12.24/2107 - Release Date:
05/12/09 18:03:00
Other related posts:
