MessageWell, if your surface works with the Mackie protocol then, you may wish to read the book that I pointed you too. Regards, Phil Muir P J Muir Productions, Music And Audio Production Telephone: US (615) 713-2021 UK+44-1747-821-794 Mobile: UK +44-7968-136-246 E-mail: info@xxxxxxxxxxxx URL: www.philmuir.com/ ----- Original Message ----- From: Stefan Albertshauser To: ddots-l@xxxxxxxxxxxxx Sent: Wednesday, May 13, 2009 4:09 PM Subject: [ddots-l] AW: AW: Re: control surfaces The only thing, I want to do is to navigate to the properties dialog of the surface in order to reassign the knobs. The only thing in the tutorial was the control of automations. -----Ursprüngliche Nachricht----- Von: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx]Im Auftrag von Stefan Albertshauser Gesendet: Mittwoch, 13. Mai 2009 17:02 An: ddots-l@xxxxxxxxxxxxx Betreff: [ddots-l] AW: Re: control surfaces I'm using a miditech MTB-Command, which supports the Mackie Protokol. -----Ursprüngliche Nachricht----- Von: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx]Im Auftrag von Kevin Gibbs Gesendet: Mittwoch, 13. Mai 2009 16:56 An: ddots-l@xxxxxxxxxxxxx Betreff: [ddots-l] Re: control surfaces What control surface are you using? -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of neville Sent: Wednesday, May 13, 2009 9:06 AM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: control surfaces Press alt O for options and then press c for control surfaces. Tab down to add a control surface and choose yours from the list. Press tab again for in puts and then again for out puts. The first tab is the in put and the second tab is the out put. After you have done this you can press alt F4 to close the dialog. That's it. May the peace of God that passes all understanding guard your heart and mind in Christ Jesus God Bless You! email neville@xxxxxxxxxxxxxxxx Website http://www.nevillepeter.com phone number 407-222-4488 ------------------------------------------------------------------------ From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Stefan Albertshauser Sent: Wednesday, May 13, 2009 8:08 AM To: Ddots-L@xxxxxxxxxxxxx (E-Mail) Subject: [ddots-l] control surfaces Hi, I want to configure my new control surface. Where can I find the properties dialog? or: in which lesson in the tutorial do I find the right informations? I've already searched Lesson 31. Thanks Stefan No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.325 / Virus Database: 270.12.24/2107 - Release Date: 05/12/09 18:03:00