Open up the plug-in that you wish to automate parameters in and locate the automation right button in the plug-in window that you're using and press the enter key to turn it on. Then locate the parameter in the plug-in or, in the track inspector and move it. When finished, turn off the automation right button in the plug-in. Regards, Phil Muir Accessibility Training Telephone: US (615) 713-2021 UK +44-1747-821-794 Mobile: UK +44-7968-136-246 E-mail: info@xxxxxxxxxxxxxxxxxxxxxxxxxxx URL: http://www.accessibilitytraining.co.uk/ -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Polaris-17 Sent: 21 August 2010 12:21 To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Drawing automation / envelopes Hello, Is there any way to draw automation for example for band frequency parameters like it is explained in Lesson 48C about drawing controller envelope in point 8? I tried to make an envelope in clips pain by selecting desired fragment of a clip then application key, then envelopes->track envelopes->eq->band2 frequency, but nothing happend. Any help will be very appreciated. Regards, Polaris-17 PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq