[ddots-l] Re: Drawing automation / envelopes
- From: "Annabelle Susan Morison" <foristnights@xxxxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Tue, 24 Aug 2010 17:02:42 -0700
Interesting you should ask about Automation and Envelopes, I'm having that
situation with fade-ins and fade-outs. Though the fade-in is at a decent
amount of time, 5000 MS, I'm wanting to make the fade-out longer, since 5000
MS doesn't seem to do the trick. Even though both are slow curves, the
fade-out sounds not so slow, whereas the fade-in is a slow and smooth
change. What do I do next?
-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On
Behalf Of "Polarus (Patryk Mis)"
Sent: Tuesday, August 24, 2010 3:50 AM
To: ddots-l@xxxxxxxxxxxxx
Subject: [ddots-l] Drawing automation / envelopes
Hello,
Is there any way to draw automation for example for band frequency
parameters like it is explained in Lesson 48C about drawing controller
envelope in point 8?
I tried to make an envelope in clips pain by selecting desired fragment
of a clip then application key, then envelopes->track
envelopes->eq->band2 frequency, but nothing happend.
Any help will be very appreciated.
Regards,
Polaris-17
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.441 / Virus Database: 271.1.1/3089 - Release Date: 08/23/10
06:35:00
No virus found in this outgoing message.
Checked by AVG - www.avg.com
Version: 8.5.441 / Virus Database: 271.1.1/3089 - Release Date: 08/24/10
15:31:00
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
Other related posts:
