Latency & echoing are definite problems with input monitoring. Echoing can
be cured by muting the inputs of your sound card. But, latency, no matter
how low you set the latency slider in Audio Options will always give some
lag between playing a note and hearing it-really screws up your performance
unless you can get used to that delay effect. A high latency setting causes
a significant delay, but, if you set the latency slider too low in an
attempt to diminish the lagtime, you'll get audio dropouts-screwed either
way.
I use WDM drivers, and this has been my experience with input monitoring.
Wolfgang
In order for you to hear the effects in realtime, you must turn on input echo.
Right arrow through your tracks, until you get to a button that says input echo. By default it is off. press enter to turn it on.
HF
HF
----- Original Message ----- From: "Wolfgang Angermann" <wolfgang.angermann@xxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx>
Sent: Saturday, May 13, 2006 2:44 PM
Subject: [ddots-l] Listening to inserted effects while recording
Hello cakeTalkers,
with destructive as well as with non-destructive effects I did not find a way to let them sound while recording. That means, I have to use the guitar "dry" and only then insert the distortion effect. However, it sure is a difference playing it with or without hearing the distortion effect. Of course, I could use an External machine for that. I just think there must be something I didn't realize with sonar so far.
Can anyone give some help?
Thanks in advance!
Wolfgang
** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
