Hey Bill this usually happens if you forget to lets say turn on your sound module, and then shut down sonar, and reopen if with the module connected at times it screws up the chain of instrumentation you have installed, including midi inputs and outputs. This is why I always when training my clients tell them to first ensure that all their equipment is turned on before going in to sonar.
.----- Original Message ----- From: "Dancing Dots" <billlist1@xxxxxxxxxxx>
To: <ddots-l@xxxxxxxxxxxxx> Sent: Monday, February 23, 2009 9:28 AM Subject: [ddots-l] Re: Midi or synchronization Problem
Dear Wolfgang,Might you have the Frontier TranzPort or another control surface attached toyour PC? When I have this problem, I too hear random MIDI percussion sounds. I have found that sometimes Windows or SONAR (I am not sure which or either!) gets confused and I have to reset the input and output values for the port settings of my TranzPort. Run SONAR and go to Options | Controllers/Surfaces. Tab to the list of control surfaces and highlight the one you use. Press RIGHT ARROW to move to Input or Output columns. Then press ENTER to open a list of ports you can select. HTH, Bill Bill McCann Founder and President of Dancing Dots since 1992 www.DancingDots.com Tel: [001] 610-783-6692 No virus found in this outgoing message. Checked by AVG. Version: 7.5.516 / Virus Database: 270.11.3/1967 - Release Date: 2/23/2009 7:17 AM PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq
PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribeFor other list commands such as vacation mode, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq orsend a message, to ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type faq