Thanks Rui. Will definitely try and didn't think about the automation so could be. ----- Original Message ----- From: Rui Vilarinho To: ddots-l@xxxxxxxxxxxxx Sent: Sunday, February 26, 2012 3:28 PM Subject: [ddots-l] Re: problem adjusting volume on tracks Hi Dave, Strange! isnt it?. To only happen to the volume adjustment! Dont know if this have something to do with that problem but anyway , is the volum automation write enable? Tip. alt plus the A key twice to unarme all automation controls that were arm. Well, save the project with a diferent name and as a bundle project and open it again. check if gets ok! best regards, Rui Vilarinho ----- Original Message ----- From: Dave Hillebrandt To: ddots-l@xxxxxxxxxxxxx Sent: Sunday, February 26, 2012 8:03 PM Subject: [ddots-l] Re: problem adjusting volume on tracks Hello, I did turn out being on the track view and still no luck determining what mihgt be open that would cause this. Everything else acts as normal except for volume adjustment. Will run through everything again but definitely driving me crazy. i can enter a number by the keyboard and press enter and then that track's volume will be brought to the new level, but no way to go up and down with the arrows to get plus and minus values as i could before. ----- Original Message ----- From: Rui Vilarinho To: ddots-l@xxxxxxxxxxxxx Sent: Saturday, February 25, 2012 1:11 PM Subject: [ddots-l] Re: problem adjusting volume on tracks Hi, Usually that could happen if you have a plugin open, with control tab, check it and close it with control f4. Then press f6 to display and refresh track view. Or. press shift arrows right or left, it must be define as a custom cake talking tab. Or. Go to view options and check if you are on the track view. just in case of you have opened another view or feature. good luck! best regards, Rui Vilarinho ----- Original Message ----- From: Dave Hillebrandt To: ddots-l@xxxxxxxxxxxxx Sent: Saturday, February 25, 2012 4:32 PM Subject: [ddots-l] problem adjusting volume on tracks Hello Friends, Well, have obviously changed a setting by mistake and now am not able to adjust the volume on individual tracks. Another words, will have a project open and usually if I press enter when over volume on track 1, I could usually go up and down with the arrows and could select a value plus or minus db on a track that already has something recorded on it..... Well, now this doesn't happen and when I go up or down with the arrows it just mentions something about processing rate etc. Obviously have done something and hoping someone has an idea of what it could be. Any suggestions are greatly appreciate as what I might have done and how to put it back correctly. It is hard enough using the volume this way using software rather than a mixer with real faders and knobs (control surface) but now appears to have no control at all. Please help. Sincerely, Dave