Hi,
I know what i can do with the ASIO drivers. This pc doesn't have an
internal microphone and I don't have a mic that jacks into the 1/8
inch jack either so if I'm not using my multitrack DAW I'd like to use
the soundcard as a soundcard. It works fine, I can hear people and
they can hear me. The only issue is that by default the XLR jacks seem
to cover only one channel. Hence my question, can I somehow either sum
the two or just take one jack and make it mono and in the center?
Regards,
Florian
2016-02-15 23:10 GMT+01:00, Mike Tyo <mtyo@xxxxxxxxxxxx>:
Hi Florian,PLEASE READ THIS FOOTER AT LEAST ONCE!
If it were me, I'd use that sound card strictly for your multi-track
application and use your internal sound card for your chat programs - etc.
If you're using an ASIO driver for the Quad, the common practice is not to
share that driver with other programs so as to get optimal performance from
it. The same goes for running JAWS; route it through the internal sound card
as well. You'll have less chance to gum up the works.
Hope this helps.
Mike
----- Original Message -----
From: "Florian Beijers" <florianbeijers@xxxxxxxxx>
To: "ddots-l" <ddots-l@xxxxxxxxxxxxx>
Sent: Monday, February 15, 2016 16:49
Subject: [ddots-l] quad capture mono in realtime?
Hi,
I am using the quad capture in my studio but also on time to time for
Voice Chatting applications. In these applications, I am noticing the
XLR jacks each take one of the two stereo channels. This is nice for
if you are inputting a left and right channel into these XLR jacks,
but for a single mic it means I am actually coming from only one
channel for others. I was wondering if there's a way to toggle these
inputs to a mono signal?
Regards,
Florian
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
