[duxuser] Re: Interpoint Embossing Not configured Correctly
- From: "Steve Dresser" <s.dresser@xxxxxxxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Mon, 21 Nov 2011 15:46:14 -0500
Eileen,
Try resetting the Juliet to factory defaults. With the settings you
described, your pages should be a bit close to the top, but you can set a
top margin of 1 in DBTW to fix that.
Steve
----- Original Message -----
From: "Eileen Misrahi" <eileenmis@xxxxxxxxxxxxxx>
To: <duxuser@xxxxxxxxxxxxx>
Sent: Monday, November 21, 2011 11:02
Subject: [duxuser] Interpoint Embossing Not configured Correctly
Hi List Serve,
I did post this to the list last week, but I must have had the wrong
address
to the list because it was never posted. So, I will posed this concern
again.
I received a new replacement laptop from Dell last week. I am running Win
7-64 bits, with a Juliette Pro 60 using a parallel-to-USB adaptor. I
established a generic-text printer and found the port connection fine. I
am
using DBT 11, SR2. I set up the embosser in DBT as a generic interpoint
printer, on wide 11 inch paper. The settings are 40 cells, 25 lines, 0 top
margin, 0 left margin. When I go to emboss, the printer will embossed the
first page with 3 lines on the back side. It then prints a full page with
no
interpoint on it, followed by three lines. This seems to be the pattern.
How
can this be fixed so that I get the Juliette Pro 60 to emboss on both
sides
correctly? Please advise with any suggestions to resolve this problem.
Thanks in advance.
Eileen
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org . The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org . The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *
Other related posts:
