Hi List Serve, I did post this to the list last week, but I must have had the wrong address to the list because it was never posted. So, I will posed this concern again. I received a new replacement laptop from Dell last week. I am running Win 7-64 bits, with a Juliette Pro 60 using a parallel-to-USB adaptor. I established a generic-text printer and found the port connection fine. I am using DBT 11, SR2. I set up the embosser in DBT as a generic interpoint printer, on wide 11 inch paper. The settings are 40 cells, 25 lines, 0 top margin, 0 left margin. When I go to emboss, the printer will embossed the first page with 3 lines on the back side. It then prints a full page with no interpoint on it, followed by three lines. This seems to be the pattern. How can this be fixed so that I get the Juliette Pro 60 to emboss on both sides correctly? Please advise with any suggestions to resolve this problem. Thanks in advance. Eileen * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to duxuser-request@xxxxxxxxxxxxx . You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting www.freelists.org . The list archive * is also located there. * Duxbury Systems' web site is www.duxburysystems.com * * *