You must have done something in the speech menu, which is **not** part of
my script.
Have no fear, you can go into the configuration, find the speech menu, and
turn off speech.
Exactly how to do that is not something I can answer quickly. Please call
tech support. Or do it yourself.
-- David Holladay
I did follow your commands- It works, but now the Blazer speaks all commands. I just use it for embossing, and not speech. How do I turn it off? It really slows down the embossing.
----- Original Message -----
From: <mailto:david@xxxxxxxxxx>David Holladay
To: <mailto:duxuser@xxxxxxxxxxxxx>duxuser@xxxxxxxxxxxxx
Sent: Monday, May 08, 2006 12:15 PM
Subject: [duxuser] Re: (No Content-class: urn:content-classes:message
On this issue, I respectfully will say that George is wrong.
Set the lines per page to zero. That gives control of the page flip to DBT.
Please follow the script I gave, and see if that works. If it does not, call tech support.
-- David Holladay
At 12:12 PM 5/8/2006, you wrote:Line length is 25 Margins are both 0 Characters per line is 34 How do I check form length? ----- Original Message ----- From: <mailto:george@xxxxxxxxxxxxxxxxxxx>George Bell To: <mailto:duxuser@xxxxxxxxxxxxx>duxuser@xxxxxxxxxxxxx Sent: Monday, May 08, 2006 9:47 AM Subject: [duxuser] Re: (No Content-class: urn:content-classes:message
There could be a number of reasons.
1) Check both your form length in DBT, and that of the Blazer.
2) Check your Lines per page in DBT. With 11 inch paper, you would normally expect to get 25 lines.
3) Top and bottom margins. Make sure they are either at zero, or that you have deducted the margin number from the lines per page.
George.
----------
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of torrenceg@xxxxxxxxx
Sent: 08 May 2006 16:19
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser]
When I emboss from Duxbury to a Blazer, a blank page is inserted after every page of Braille. Any suggestions?