Hello Caroline: Are you using DBT WIN 10.5 sr1? If oyu are set the TIGER up for Normal mmode. In DBT completet your EMBOSSER SETUP in the GLOBAL menu, then complete EMBOSSER SETUP I nteh DOCUMENT menu. DO NOT RUN THE TIGER in classi mode and you should be fine. Any problems please contact our Tech support at: support@xxxxxxxxxx or via telephone at 978-692-3000 Neal Email: Neal@xxxxxxxxxx _____ From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Caroline Congdon Sent: Sunday, July 31, 2005 12:11 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Setting up the Tiger Max with DBT 10.5 Hi everyone. I'm looking for anyone who has successfully gotten the Tiger Max to work with DBT. I was working on getting one set up this morning, and I'm not having a lot of luck. The software that it comes with is working, and things are printing, so I know that things are aligned correctly. What's happening is that whenever I print, pages are printing very far off the left-hand side of the page. I have tried printing both in Tiger mode and in Legacy mode. When I try to print in Legacy mode, even though I'm using form-feed paper, I keep getting the message that all odd pages need to print and then to turn the paper over to print the even pages. This is not what I want to do. Can anyone give me any pointers or suggest anywhere I can go to read more about this embosser? I've been looking at the manual online, but it really doesn't say much about Duxbury other than to say that the software uses DBT to do its translations. Thanks in advance for any help. Caroline