Aloha listers,
I second this. We buy the tractor feed advesive sheets from American
Thermoform. I once saw an embosser with a label that had gotten stuck
inside. They had to have half of the hammers replaced in it.
Betsy
At 01:59 PM 11/18/2002 -0500, you wrote:
Hi Barb,
I'd be very careful about attaching a piece of plastic to a sheet of paper and trying to run it through an embosser. There's a good chance the plastic might jam as it's being pulled through the embosser mechanism. Even if you could find a fool-proof way to attach the plastic to the paper, you'd have to be sure your embosser could make reasonable dots without being damaged, or destroying the plastic.
Steve
* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *
* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *