[duxuser] Re: problems embossing with bt100
- From: David Holladay <david@xxxxxxxxxx>
- To: duxuser@xxxxxxxxxxxxx
- Date: Mon, 29 Nov 2010 15:10:48 -0400
Everyone:
I would like to tell the Duxusers that I have communicated off-list to Pat,
and have tracked down the problem (his computer cannot initialize the
serial port, but DBT offers a workaround).
Contact me off the list if you have any questions about this.
-- David Holladay
Duxbury Systems
At 01:26 PM 11/29/2010, you wrote:
Hi Everyone,
I am having difficulties with my bt100 Braille Embosser. Everything seems
to go fine, until I give the command to emboss.
What I get back is after pressing (control e) is:
embosser failed
error at line 1146 in
dxemb_job.c:
access is denied,
and it lists the number
[5/0x00000005]
I hope I have given this information correctly.
I know that the bt100 is loaded properly because when I turn it on, it
spits out a page and brings in another to make sure that everything will
be properly running.
Any help would be greatly appreciated! Thanks!
All the Very Best!
Pat
* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
