[python] brazing
- From: brian smith <briannsmith@xxxxxxxxxxxxx>
- To: python@xxxxxxxxxxxxx
- Date: Wed, 21 Nov 2007 09:00:01 -0500
Wild ideas strike me while on my actionbent recumbent.
What are the pros and cons of lashing up the frame of a python with
clean steel wire?
In some wood structures ...... I've made very strong permanent joints
with multiple turns of fine braided nylon cord all embedded in epoxy.
So what about the same principle for metal?
After appropriate preparation fix the surfaces to be joined with many
tight turns of wire then flow he brazing metal into the strands of wire.
Tho oxy-acetylene is optimal for brazing the garage constructor might
find the high temp bottled gas OK and a whole lot cheaper than all the
gear needed for O-A brazing.
The wire might also be used to avoid having to make elaborate jigs to
hols all in place while welding or brazing.
I toss this up without having any direct experience.
Warmest regards to all who make pythons,
Brian in SC USA
============================================================
This is the Python Mailinglist
//www.freelists.org/list/python
Listmaster: Jürgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to
python-request@xxxxxxxxxxxxx
with 'unsubscribe' in the subject field.
============================================================
Other related posts:
