I asume you are talking about HID Buttons. I think this will not work. But you can declare a vol control for the input in your AC Interface section this will work and you can control the volume with SndVol32.exe /r. Of course you need some dsp functions on firmware level to change the volumes or codec with vol control. Cheers Thomas ----- Original Message ----- From: Ajai James <ajaijames@xxxxxxxxx> To: <wdmaudiodev@xxxxxxxxxxxxx> Sent: Monday, September 23, 2002 8:53 PM Subject: [wdmaudiodev] Audio control for recording not possible??? > > Hi friends, > I am using an Ez USB board to prepare a demo audio project.I have a requirement to increase the volume of my recorded wav file depending on the buttons on my kit, ie vol up and down. The enumeration is ok now, and the firmware keeps on pumping the hard coded sine tone values to the host.So, after selecting th enumerated board as a recording device, I can record the sine tone. Now, i want to change the volume of the sine tone using my boards f1, f2 push buttons. I thought I could use the control end point with Vol up, vol down for that. But it does not seem to work. > On going through microsoft documentation ,http://www.microsoft.com/hwdev/tech/input/audctrl.asp > it seems that audio controls are supported for play back only, not recording.. > Am i correct in this assumption? any way to implement this without using the audio controls > > Thanks a lot, for your kind suggestions and comments ... > Ajai James > > > > > > > --------------------------------- > Do you Yahoo!? > New DSL Internet Access from SBC & Yahoo! > > ****************** > > WDMAUDIODEV addresses: > Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx > Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe > Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe > Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx > > URL to WDMAUDIODEV page: > http://www.wdmaudiodev.de/ > ****************** WDMAUDIODEV addresses: Post message: mailto:wdmaudiodev@xxxxxxxxxxxxx Subscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=subscribe Unsubscribe: mailto:wdmaudiodev-request@xxxxxxxxxxxxx?subject=unsubscribe Moderator: mailto:wdmaudiodev-moderators@xxxxxxxxxxxxx URL to WDMAUDIODEV page: http://www.wdmaudiodev.de/