Cool, thanks again.
Just out of curiosity, if I had a case that mandated support for other
formats too, what options would I have? Can a driver specify the channel
config it wants the endpoint to come up in at the time of endpoint
registration?
On Tue, Feb 16, 2016 at 10:28 PM, Matthew van Eerde <
Matthew.van.Eerde@xxxxxxxxxxxxx> wrote:
Yes; no; I hope not.
*From:* wdmaudiodev-bounce@xxxxxxxxxxxxx [mailto:
wdmaudiodev-bounce@xxxxxxxxxxxxx] *On Behalf Of *ambrish dantrey
*Sent:* Tuesday, February 16, 2016 8:53 AM
*To:* wdmaudiodev@xxxxxxxxxxxxx
*Subject:* [wdmaudiodev] Re: Default channel format for MsVAD driver
Thanks.
Is this allowed by MS? Isn't stereo a mandatory channel format to be
supported by all devices? Would I have issues with WHQL tests when I run
them?
On Feb 16, 2016 10:20 PM, "Matthew van Eerde" <
Matthew.van.Eerde@xxxxxxxxxxxxx> wrote:
The simplest option is to support *only* 5.1.
*From:* wdmaudiodev-bounce@xxxxxxxxxxxxx [mailto:
wdmaudiodev-bounce@xxxxxxxxxxxxx] *On Behalf Of *ambrish dantrey
*Sent:* Tuesday, February 16, 2016 8:44 AM
*To:* wdmaudiodev@xxxxxxxxxxxxx; Anshul Gupta <aarjavi20@xxxxxxxxx>
*Subject:* [wdmaudiodev] Default channel format for MsVAD driver
Hi Guys,
I am using a modified version of MsVAD driver that always exposes 5.1
channel configuration. I want the MsVAD endpoint to be setup in 5.1 channel
mode by default after driver installation. Currently it is setup in stereo
format.
How do I enable this from within MsVAD driver? Any suggestions?
Thanks,
Ambrish
