Hello, Donald, Place your cursor at the page break {pg} command. You can select the Codes List with F5 and press the letter P. Arrow down to the {pv} command. Tab to code parameters and type the number 1. You could also type in the code manually as {pv1}. All the best, Judith Meyers -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx]On Behalf Of Donald L. Roberts Sent: Thursday, December 15, 2005 2:03 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Arbitrary assignment of braille page numbers Hello, I have a large project to braille using DBT win 10.4. This project consists of seven source files. However, I want the finished braille project to have its pages numbered sequentially commencing with page 1. I know how to change the page numbering option in the header selection to 1. However, what I do not know how to do is to assign a braille page number to the first page of the second source file and then the third, the fourth, etc. Please offer suggestions or point me to the appropriate section of the documentation. Cordially, Don Roberts * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *