You would set your Juliet to factory defaults, then set your paper size, top margin, etc. in Duxbury. -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Francis Daniels Sent: Tuesday, July 08, 2008 8:13 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Juliet Classic and Duxbury Hello all, I am setting up Duxbury 10.6 with a used Juliet Classic. It will do interpoint, although the operator does not want that as the default. I know how to set that in Duxbury. I want to use Menu 1 for the default menu for the Juliet. As it is right now, when I did a test run, the braille document embossed way too far to the left, over the binding slots. It also started printing extremely close to the top of the paper. Do I set the embossing defaults for the binding offset and page top on the Juliet and let Duxbury print to them, or do I set the binding offset and page top in the Global defaults and document settings in Duxbury? I suspect I would have to control the Juliet through Duxbury, but I'm not sure of this. I have the Juliet manual at work, so cannot check settings here at home. Thank you, if someone has any suggestions. Francis Daniels * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *