Hi David,
I am George Bell, Bill McCann's distributor in the UK and an Enabling
Technologies dealer here too - as well as Duxbury of course!
In these circumstances we would suggest a Reset as described below. If the
problem still persists when you emboss the menu options, it is almost certainly
an embosser fault, and hopefully Enabling Technologies themselves will be able
to advise. Phone: (+1) 772 225 3687
Restoring Factory Settings
If you change too many menu parameters to keep track of, or if you're not the
only person to use the embosser, you might want to reset the embosser back to
the original factory settings. Although you will lose all changes you've made
to the menus, you'll also be starting fresh.
OL Takes the embosser off-line
0.0E Enter the Service Menu
95E Restore the factory default settings
1E Reset the embosser
George
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On ;
Behalf Of David Pinto
Sent: 04 January 2017 23:38
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Romeo RB-25 Skipping pages
Hi All,
I'm David Pinto, and am new to this group. I have an Academy of Music for the
Blind in the USA and after 4 years of not using our Romeo RB-25 embosser we
just fired it up again. Unfortunately, when embossing anything it consistently
skips pages even if there are no page breaks. For instance, I might have 12
lines of Braille to be embossed on one page, but it brailles it across perhaps
2 or 3 pages . . . . losing it's top of form orientation.
When I use the Romeo's keypad commands to automatically emboss a list of all
the Romeo's menu options, the page skipping also occurs. So, it's probably the
machine rather than my Duxbury 12.1 or the Windows 10 laptop (laptop USB to
Romeo's Serial).
Any thoughts on how to address this problem? The machine is in great shape
otherwise.
Thanks in advance!
David