[duxuser] Skipping to the next page after one line

  • From: Ann Byrne <annakb@xxxxxxxxxxxxx>
  • To: duxuser@xxxxxxxxxxxxx
  • Date: Mon, 19 Sep 2005 16:54:43 -0500

I know I did it myself, but I can't persuade my Juliet to write 27 lines on a page instead of just one. If I tell it to emboss pages 3-4, it makes a single line on each page, and goes to the next page. If I ask for pages 3-6, I get one line on 3-4 and one line on 5-6.

In embosser setup, edit, I was looking at settings and advanced settings. There are selections for new page. Of course, I don't believe I changed them. But if someone could run through what the settings should be--in such a way as to solve my problem--I would be soooooooo appreciative.

this is what I have.  Duxbury 1.05, SR1.

use custom job set up, not checked.
end of line and page end of line indicator: carriage return, line feed pc (1 of 3)
end of line and page end of page indicator: end of line and form feed (1 of 5)
End of line and page EOL on a full line: not checked
end of line and page eop on a full page: not checked
end of line and page pad lines: not checked
end of line and page prompt for new sheet: not checked
timing, send one character at a time: not checked

Thanks a bunch.

Ann




* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
*   unsubscribe
* as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org.  The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *

Other related posts:

  1. Home
  2. duxuser
  3. Archive
  4. 09-2005