Hello: Have you tried to reset your Juliet to the factory defaults? If you want to try, here's how: Do this like so. 1. take the juliett off line. 2. type 0.0e on the keypad. 3. type 95e 4. type 1e and wait for the embosser to reset itself. Now your ready to braille. ----- Original Message ----- From: Ann Byrne To: duxuser@xxxxxxxxxxxxx Sent: Monday, September 19, 2005 4:54 PM Subject: [duxuser] Skipping to the next page after one line I know I did it myself, but I can't persuade my Juliet to write 27 lines on a page instead of just one. If I tell it to emboss pages 3-4, it makes a single line on each page, and goes to the next page. If I ask for pages 3-6, I get one line on 3-4 and one line on 5-6. In embosser setup, edit, I was looking at settings and advanced settings. There are selections for new page. Of course, I don't believe I changed them. But if someone could run through what the settings should be--in such a way as to solve my problem--I would be soooooooo appreciative. this is what I have. Duxbury 1.05, SR1. use custom job set up, not checked. end of line and page end of line indicator: carriage return, line feed pc (1 of 3) end of line and page end of page indicator: end of line and form feed (1 of 5) End of line and page EOL on a full line: not checked end of line and page eop on a full page: not checked end of line and page pad lines: not checked end of line and page prompt for new sheet: not checked timing, send one character at a time: not checked Thanks a bunch. Ann * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *