TAM As I recall, I haven't used 10.4 inn a long time, after you import the graphic try the following: In Dux 10.4 Place your cursor back at the top left of the graphic. Across the toolbar go back to layout, down to picture, right to add. Then select a high resolution mode 2.0 or 1.6 The diagram should emboss then. These problems have been rectified in 10.5 David A. Skrivanek Repro-Tronics Inc. Davesrepro@xxxxxxx daves@xxxxxxxxxxxxxxxxx davesrepro@xxxxxxxxxxx _www.repro-tronics.com_ (http://www.repro-tronics.com/) phone: 800-948-8453 201-722-1880 fax: 201-722-1881