[duxuser] Re: printing errors with DBT
- From: "Watson, Robert" <RWatson@xxxxxx>
- To: <duxuser@xxxxxxxxxxxxx>
- Date: Fri, 22 Jul 2005 11:24:13 -0400
Yes-tried that. And get this - the same printing test and document
embosses just fine from Megadots.
________________________________
From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx]
On Behalf Of George Bell
Sent: Friday, July 22, 2005 11:21 AM
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: printing errors with DBT
If this is happening with BOTH embossers, my first thought is that you
may have a dud parallel cable - assuming you are connected parallel of
course.
I presume you have also tried a system re-boot?
George.
________________________________
From: duxuser-bounce@xxxxxxxxxxxxx
[mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Watson, Robert
Sent: 22 July 2005 15:45
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] printing errors with DBT
An unusual problem (I think). When I emboss a document that is
38-40 characters wide, using wide width paper in either my Romeo or
Versapoint Duo, I get a "gap" between cells 28 and 32. In other words,
nothing prints in that range. I have checked my settings on the global
settings page , as well as just for the document and they are calling
for the correct lines per page, width etc. Anyone had anything like this
before?
Other related posts:
