Hi Arpad, In the templates I sent, you can see the node ordering that CDS uses in our B-elements. I included them as comments right in the model file, so you can see how it is set up. It would make sense to me to use this same ordering, as we are providing the templates. It is attached below. Ken * The terminals in an 8-terminal differential MacroModel are as follows: * power = 1 * outp = 2 * ground = 3 * input = 4 * enable = 5 * power_clamp_reference = 6 * ground_clamp_reference = 7 * outn = 8 -----Original Message----- From: ibis-macro-bounce@xxxxxxxxxxxxx [mailto:ibis-macro-bounce@xxxxxxxxxxxxx] On Behalf Of Muranyi, Arpad Sent: Monday, October 03, 2005 1:32 PM To: ibis-macro@xxxxxxxxxxxxx Subject: [ibis-macro] Node ordering for IBIS buffer building blocks Hello, I have a question about the order of the nodes for the IBIS buffer building blocks in the library. What should be our convention? 1) Should we follow the order of nodes as it is done in the HSPICE B-elements? 2) Should we have any other ordering scheme? For example, have the "digital" (i.e. control) nodes first, such as In_D, En_D, Rcv_D, and then the analog ports? 3) Any other suggestions? Thanks, Arpad ================================================================== --------------------------------------------------------------------- IBIS Macro website: http://www.sisoft.com/ibis-macro IBIS Macro archives: //www.freelists.org/archives/ibis-macro To unsubscribe send an email: To: ibis-macro-request@xxxxxxxxxxxxx Subject: unsubscribe --------------------------------------------------------------------- IBIS Macro website: http://www.sisoft.com/ibis-macro IBIS Macro archives: //www.freelists.org/archives/ibis-macro To unsubscribe send an email: To: ibis-macro-request@xxxxxxxxxxxxx Subject: unsubscribe