I’m not sure what you are describing. The Say All command isn’t working for
you at all? I could just be not getting it on a Sunday afternoon, but can you
describe exactly what is happening?
Take Care
John D. Panarese
Director
Mac for the Blind
Tel, (631) 724-4479
Email, john@xxxxxxxxxxxxxxxxxx
Website, http://www.macfortheblind.com
APPLE CERTIFIED SUPPORT PROFESSIONAL and Trainer
AUTHORIZED APPLE STORE BUSINESS AFFILIATE
MAC and iOS VOICEOVER TRAINING AND SUPPORT
On Aug 7, 2016, at 11:11 AM, Daniel McGee <danielmcgee134@xxxxxxxxxx> wrote:
Hello everyone.
Are any of you experiencing VoiceOver stopping from a read all if your system
preferences energy saver settings are set to the bare minimum with OSX el
capitan?
Can't seem to remember what or even how my energy saver settings were set
from Yosemite but the obvious reason why I would rather set them to the
lowest is to conserve as much battery life as possible and I'm getting a
sense that el capitan is using more than it should. Even though I have my
brightness all the way down to 0 percent.
Any thoughts, tips or even places I might check on the system would be really
appreciated. Should point out too that this was by chance a clean install of
the OS so any lingering stuff from my past upgrades shouldn't of effected
this newer OS in any form from a clean install perspective.
Thanks
Daniel ************
You are subscribed to the mac4theblind mailing list.
The url for this list, where one can unsubscribe or make any changes to
their list subscription is:
//www.freelists.org/list/mac4theblind
The list archive is located at
//www.freelists.org/archive/mac4theblind/
All emails intended for the list owner can be sent to:
john@xxxxxxxxxxxxxxxxxx
