Thanks scott, I actually just found the same manual, but it was posted on one
of those heavy ad based manual sites. They make it nearly impossible to
navigate a service manual. This one is way better.
It didn't take long for me to check the voltage coming out of the transformer.
Looks like there's nothing there...
I think I'll check the warranty card and maybe drop by the pharmacy location
and see if I can get a new transformer.
In all seriousness, I feel like it's going to be easier to find another 802
then it will be to find a power supply for one....
Thanks!
this email was composed and sent from my smartphone. please excuse any errors
Ben Kayfetz
416-831-6339
________________________________
From: torontocbm-bounce@xxxxxxxxxxxxx <torontocbm-bounce@xxxxxxxxxxxxx> on
behalf of Scott Davis <sdavis@xxxxxxxxxxxxx>
Sent: Tuesday, May 11, 2021 11:45:30 AM
To: torontocbm@xxxxxxxxxxxxx <torontocbm@xxxxxxxxxxxxx>
Subject: [torontocbm] Re: MPS 801 capacitor?
Hey Ben, check this out:
https://www.commodoreman.com/Commodore/Library/Man/1526_MPS802_4023_ServiceManual.pdf
I searched for “commodore MPS-802 circuit diagram”. 😊
Scott Davis,
Escape Technologies.
(416) 432-4334
45 Dunfield Ave, Suite 2117
Toronto, ON, M4S 2H4
From: torontocbm-bounce@xxxxxxxxxxxxx <torontocbm-bounce@xxxxxxxxxxxxx> On
Behalf Of Ben Kayfetz
Sent: Tuesday, May 11, 2021 11:18 AM
To: torontocbm@xxxxxxxxxxxxx
Subject: [torontocbm] Re: MPS 801 capacitor?
Yes, fuse is good. First thing I checked when it was totally dead.
And yes, on closer inspection, that that might be glue.
I'm not an expert, but I can trace some power wires and connectors and check
for continuity here and there.
Does anyone know what the voltage should be out of the transformer?
Ben
________________________________
From: torontocbm-bounce@xxxxxxxxxxxxx<mailto:torontocbm-bounce@xxxxxxxxxxxxx>
<torontocbm-bounce@xxxxxxxxxxxxx<mailto:torontocbm-bounce@xxxxxxxxxxxxx>> on
behalf of Jim Brain <brain@xxxxxxxxxx<mailto:brain@xxxxxxxxxx>>
Sent: May 11, 2021 10:19 AM
To: torontocbm@xxxxxxxxxxxxx<mailto:torontocbm@xxxxxxxxxxxxx>
<torontocbm@xxxxxxxxxxxxx<mailto:torontocbm@xxxxxxxxxxxxx>>
Subject: [torontocbm] Re: MPS 801 capacitor?
On 5/11/2021 8:06 AM, Ben Kayfetz wrote:
Hey guys,
I pulled a Commodore MPS 802 printer out of storage. I figured it would be a
nice upgrade from my MPS 801. Unfortunately, it did not power on. On closer
inspection it appears that these two capacitors (attached photos) are done.
Actually, I don't think those are bad. Most large caps have some glue on them
to physically hold them to the PCB. From the pics, it appears that is jsut glue
I believe the 802 has a fuse. Is it known good?
Jim