Hi all We've been using DBT 10.4 for about 4 months now quite successfully. However, last week while a staff member was embossing some work the embosser (Index Basic-D) failed to print the last 3 pages of a document. When any buttons were then pressed on the embosser it was saying "Error 3". I managed to fix that but turning off and on (always works!). However, I am now getting an error within DBT. I can open and translate a Word document but when I choose Emboss and say OK to 1 copy I get the following error... CloseJob failed: -1. GetLastError () -> 6 The document does not emboss so I'm pretty much stuck there. Can anyone help? Thanks Tim Cunningham -- Disabilities Support Technician Student Services Northumbria University 0797 497 2954 http://www.northumbria.ac.uk/disabilities ==== This e-mail is intended solely for the addressee. It may contain private and confidential information. If you are not the intended addressee, please take no action based on it nor show a copy to anyone. Please reply to this e-mail to highlight the error. You should also be aware that all electronic mail from, to, or within Northumbria University may be the subject of a request under the Freedom of Information Act 2000 and related legislation, and therefore may be required to be disclosed to third parties. This e-mail and attachments have been scanned for viruses prior to leaving Northumbria University. Northumbria University will not be liable for any losses as a result of any viruses being passed on. * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *