Good afternoon!
I have a completed document that I need to put Roman numerals in for a table of
contents. From then on, I want Arabic numbers. I would like for the Roman
numerals to start with one, but the actual page would be the third. I want all
the page numbers to be on the top right-hand corner, and for the Arabic pages
to start at one, once the Roman numeral pages are finished. I have tried
entering codes in both the braille and print file, and neither work. Aren’t
they supposed to be invisible? When I tried entering them, and switching back
to formatted view, they were still there.
So, if someone with a good knowledge of codes could get back to me, I would
appreciate it very much! I would like to get this document embossed tomorrow if
possible.
Also trying to figure out a good volume division. Including the table of
contents, the document, according to Duxberry, is 511 pages long. I cut that
number in half, because I am using interpoint. So, given that, does that mean I
can get to Volumes out of it?
Thanks in advance!
Sent from my iPhone* * *
* This message is via list duxuser at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to duxuser-request@xxxxxxxxxxxxx . You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting www.freelists.org . The list archive
* is also located there.
* Duxbury Systems' web site is www.duxburysystems.com
* * *