I have 10.4 on my embossing PC and I open the BRF files I have created using 10.6 and emboss them. Jan Carroll Contract Administration Manager American Printing House f/the Blind 1839 Frankfort Avenue Louisville, KY 40206-0085 800-223-1839 Ext. 302 Fax: 502-899-2284 Email: jcarroll@xxxxxxx >>> VCotton@xxxxxxxxxxxxx 9/13/2006 3:15:15 PM >>> Hi George I have two questions. I am still having the problem of dux reading partial words halfway through sentences even though the whole word is there. I upgraded to 10.6 and the problem still exists and another comes up for my situation at the school here in Ga. I can't clean up word files or create new dxp or dxb files in 10.6 and open them in earlier versions past 10.5. I have to use the earlier versions to emboss from because we don't have enough licenses to install 10.6 on the system which is connected to the romeo in a work room used by many other teachers. I have a stand alone copy of 10.6 on my laptop and can again clean and create files but cannot emboss because I get error messages saying somthing to the effect of needing a converter. Can you or anyone else help at all with this issue. * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *