John.. What type of embosser are you using.that may help us with your problem Lynne C. Bach Lynne2b@xxxxxxxxxxx Ph: 847-629-7503 Fax: 847-629-7514 -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of John Sanders Sent: Saturday, February 11, 2006 7:50 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Re: embosser not brailing document Hi, no the braille embosser is not braille anything. I've done that already and it still doesn't work. could you some one please help me? Sincerely, John Sanders ----- Original Message ----- From: Lynne Bach <mailto:Lynne2b@xxxxxxxxxxx> To: duxuser@xxxxxxxxxxxxx Sent: Saturday, February 11, 2006 12:57 PM Subject: [duxuser] Re: embosser not brailing document Is it brailing anything? If not working at all, start Duxbury, at the top where you find "file" "edit" go a couple more tabs and you will find settings and under that tab is embosser set up. Find your embosser on the list and save settings. If your Brailler is brailing miscellaneous information the embosser bar may need to be flipped over. This occurs on the Braille Blazer, there is a little handle on the embosser bar that my daughter use to occasionally flip and the embosser bar then is in graphing mode. Hopefully this helps. Lynne C. Bach Lynne2b@xxxxxxxxxxx -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of John Sanders Sent: Friday, February 10, 2006 6:48 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] embosser not brailling document Hi, i have a question: my braille embosser is not brailling documents. I have dux bury braille translater 10.5 service release 2. How should i go about fixing this? Sincerely, John Sanders