from the Juliet manual OL--Takes the embosser off-line 0.1E--Enter menu number 1. If you are using a different menu, substitute the alternate menu number for the 1 in the sequence 30.3E--This will set a top-of-form offset value of 3 or 0.3 inches. This setting will remain until you change it, even after power is turned off 1.1E--This will install the change and reset the embosser _____ From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Bray, Terry Sent: Tuesday, April 08, 2008 10:46 AM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] enabling printers Hi: I know this question gets asked every so often and I am not exception smile. can someone please tell me how to keep my Juliette from printing at the vary top of the page? I don't know why this issue keeps coming up because the defaults should take care of it. thanks Terry Bray System Support Analyst Adaptive Technology Services - Strategy and Planning Desktop Planning & Design ENTERPRISE INFRASTRUCTURE, Technology & Operations BMO Financial Group Phone: 416- 549-6190 Fax: 416-549-6565 E-mail terry.bray@xxxxxxx <mailto:terry.bray@xxxxxxx> Visit us at the following address http://ns.bmogc.net/ats/ Mailing Address: Bank Of Montreal 4881 Yonge Street, 8th Floor, YSC1 Yonge & Sheppard Centre Toronto, Ontario M2N 5X3