Steve, I also make sure to do a 2e to initially set the top of form before adjusting the offset in the Enabling menus. Perhaps you said this but just thought I would toss this in. Thank you! Brett Winchester KD7JN bwinchester@xxxxxxxxxxxxxxx ICBVI -- Reading Services P O BOX 83720 341 W WASHINGTON STREET BOISE IDAHO 83720-0012 208-334-3220-104 208-639-8386 DID 208-334-2963 fax ________________________________ From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Steve Dresser Sent: Tuesday, April 08, 2008 2:16 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Re: enabling printers Terry, There are two ways to fix this: 1. With the Juliet set to factory defaults, set the Top Margin in DBTW to 1. 2. With the Top Margin in DBTW set to 0, set the Juliet's Top of Form to 5 (30.5E in the Juliet's menu). The only disadvantage to this method is that you have to remember to reset Top of Form any time you reset the embosser. The advantage, however, is that the embosser will always start the page 1/2 inch from the top edge of the paper. Incidentally, the number after the decimal point in 30.5E is the distance from the top edge of the paper in tenths of inches. DBTW's Top Margin is expressed in lines. Steve ----- Original Message ----- From: Bray, Terry <mailto:Terry.Bray@xxxxxxx> To: duxuser@xxxxxxxxxxxxx Sent: Tuesday, April 08, 2008 11:45 Subject: [duxuser] enabling printers Hi: I know this question gets asked every so often and I am not exception smile. can someone please tell me how to keep my Juliette from printing at the vary top of the page? I don't know why this issue keeps coming up because the defaults should take care of it. thanks