Lloyd
Jean
In 10.5, I think DBT assumes that your embosser has been adjusted to accept escape sequences to control its setup parameters from the PC. So if "recognize escape sequences" is set to Off on your embosser, you might get these results as DBT resets the embosser to a known state at the beginning of the document.
* * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *