Hi Vojtěch,
Thank you.
I did bring it up, volume up did nothing, then volume down started
decreasing, so I up arrowed to take it back up to 100%.
So it is already at 100% apparently, but for some reason, the volume is much
lower than it was.
I went into Orca and tried adjusting the volume there, but that only
increased the distortion.
It seems that Orca does not work well over 3 or 4 for a volume setting.
But this thing was louder before.
Maybe my speaker is getting weak, but it usually does not get a weaker
volume when the battery starts to run out.
Glenn
----- Original Message -----
From: "Vojtěch šmiro" <vsmiro@xxxxxxxxx>
To: <raspberry-vi@xxxxxxxxxxxxx>
Sent: Saturday, January 02, 2021 2:45 PM
Subject: [raspberry-vi] Re: Raspberry PI Volume
Hi Glen,
Try in Terminal
alsamixer
and after that, press down arrow to volume down and up arrow to volume up.
Vojta.
Dne 02. 01. 21 v 21:37 Glenn K0LNY napsal(a):
Hi,===========================================================
I cannot find a GUI method of controlling the volume on this RPI.
I have tried in the terminal as root:
amixer set PCM 90%
but it comes back that it cannot find pcm0
Normally in Ubuntu I do this in the GUI from a control panel utility.
Thanks for any ideas.
Glenn
===========================================================
The raspberry-vi mailing list
Archives: //www.freelists.org/archives/raspberry-vi
Administrative contact: <mike.ray@xxxxxxxxxxxxxx>
-----------------------------------------------------------
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi
Foundation.
This list is not affiliated to the Raspberry Pi Foundation and the views
and attitudes expressed by the subscribers to this list do not reflect
those of the Foundation.
Mike Ray, list creator, January 2013
